01.2 - COMPONENT LOCATIONS
When you ride a motorcycle off-road, you need to be able to operate the throttle, clutch, brakes, and motorcycle. This section of the manual will describe the function, location, and operation of all the basic controls of your motorcycle.
Clutch Lever
The clutch lever A is located on the left side of the handlebar.
Hand Brake Lever & Throttle
The hand brake lever A and throttle B are mounted on the right side of the handlebar.
Choke Lever (On Handlebar) If applicable
When pulling the choke lever A toward you, a cylinder in the carburetor is opened. Through this cylinder the engine can take in additional fuel. This results in a rich fuel & air mixture, which is needed for a cold start. When releasing the choke lever, the cylinder is closed.
Choke Lever (On Carburetor)
When pulling up the choke lever A, a cylinder in the carburetor is opened. Through this cylinder the engine can take in additional fuel. This results in a rich fuel & air mixture, which is needed for a cold start. When pushing down the choke lever, the cylinder is closed.
Stop Switch
The stop (kill) switch A turn off the engine. When this button is pressed, the ignition circuit is turned off.
Start Switch (Electric Start Engine)
The start switch A turns on the engine. When this button is pressed, the electric starter will engage to start the engine. Once started, release the button.
Key Switch (No Steering Lock)
The ignition key A is used to supply power from the battery to the electrical components of the motorcycle. Turn the switch to the “OFF” position B when you are finished riding, or if you wish to stop the engine.
B - OFF position
C - ON position
Key Switch (With Steering Lock) if applicable
The ignition key A is used to supply power for the battery to the electrical components of the motorcycle in the “ON” position B Turn the switch to the “OFF” position C when you are finished riding, or if you wish to stop the engine.
To lock the steering system, turn the key to the “OFF” position A push and release the key, then rotate counter-clockwise to the “LOCK” position B.
Fuel Filler Cap
To Open: Turn the cap counter-clockwise.
To Close: Turn the cap clockwise, make sure the breather tube is installed.
Gear Shift Lever
The gear shift lever A is on the left side of the engine. The gear positions are shown in the illustration on the left. (6th gear is optional, depending on your engine).
Foot Brake Lever (Rear Brake)
The rear brake lever A is located on the right side of the engine near the foot rest. Its basic operation is to apply the rear brake to slow or stop the motorcycle.
Kick Start Lever
The kick start lever A is mounted on the right side of the engine. It is used to start the engine in case the electrical starter system is non-functional.
Side (Kick) Stand
Push the side stand to the ground and tilt the motorcycle to the left. Make sure the motorcycle is on solid ground and the position is secure.
Fuel Tap
OFF – In this position, the fuel tap is closed. No fuel can flow to the carburetor.
ON – In this position, the fuel tap is open. Fuel can flow to the carburetor. With the tap in this position, the tank will be emptied.